Item dimensions L x W x H 15 x 7.8 x 2.4 inches Voltage 12 Volts Manufacturer Rockford Fosgate Maximum Supply Voltage 14.4 Volts (DC) Mounting Type Car Mount The Punch P1000X5 is an ultra-efficient 5-channel amplifier (2.38” x 7.76” x 15.03”) capable of running your entire system without excessive drain on your charging system and rocking 1000 watts of RMS power Perfect for running a front/rear system and a dedicated subwoofer (RMS Power Output: 75 Watts x 4 + 150 Watts x 1 @ 4-Ohm OR 125 Watts x 4 + 300 Watts x 1 @ 2-Ohm OR N/A + 500 Watts @ 1-Ohm) RCA inputs can accept both Hi and Low level audio signals without the need of a signal converter and tri-stage protection that covers thermal, over-current and short circuits Featuring Class A
The P1000X5 1,000 Watt full-range 5-channel is the one-and-only amplifier you will need to run your entire system. Run dash speakers off the front channels, run back speakers off the rear channels and run subwoofer(s) off the 5th channel!
Known world-wide for brute power, this amplifier offers a higher level of efficiency along with a tri-stage protection that covers thermal, over-current and short circuits. The stealth top mounted control panel not only provides a sleek finished look to the amp, but it also protects the vital controls.
Our custom heat sink design uses high aluminum mass where it is needed most to maximize heat transfer from the output MOSFETS to the surrounding air, keeping the circuitry cool even under high power and output demand.
Punch 1000-Watt Full-Range 5-Channel Amplifier
Rated Power: See Comparison Chart Below
12dB/octave Butterworth crossover
Power Wire Gauge: 4 AWG
Speaker Wire Gauge: 12 AWG
Recommended Fuse (not included): 150 A
Optional Punch Level Control Ready (PLC2 sold separately)
Dimensions (H x W x D): 2.38" x 7.76" x 15.03"
C.L.E.A.N. Set-Up
C.L.E.A.N. (Calibrated Level Eliminates Audible Noise) is our patented circuit with in/out clip LEDs to help match a source to amp and optimize output
Punch EQ
Delivers more bass where you want it most by allowing up to 18dB of boost adjustment at 45Hz
Multi-Signal Inputs
The RCA inputs of this amp can accept both Hi or Low level audio signals without the need of a signal converter
Item dimensions L x W x H 20 x 26.5 x 6 centimetres Voltage 16 Volts Manufacturer Pioneer Maximum supply voltage 5 Volts Mounting type Surface Mount manufacturer: Pioneer Item Trademark: PIONEER Item Weight: kilograms, pounds, 5.732018812, 2.6 Item Category: Electronic Component Amplifier
Item dimensions L x W x H 15 x 7.8 x 2.4 inches Voltage 12 Volts Manufacturer Rockford Fosgate Maximum Supply Voltage 14.4 Volts (DC) Mounting Type Car Mount The Punch P1000X5 is an ultra-efficient 5-channel amplifier (2.38” x 7.76” x 15.03”) capable of running your entire system without excessive drain on your charging system and rocking 1000 watts of RMS power Perfect for running a front/rear system and a dedicated subwoofer (RMS Power Output: 75 Watts x 4 + 150 Watts x 1 @ 4-Ohm OR 125 Watts x 4 + 300 Watts x 1 @ 2-Ohm OR N/A + 500 Watts @ 1-Ohm) RCA inputs can accept both Hi and Low level audio signals without the need of a signal converter and tri-stage protection that covers thermal, over-current and short circuits Featuring Class A